I’ve finally been connected to a fiber connection 2,5/1Gbps! 🥳 Now I want to share my connection with my neighbor and so I’ve installed 3 PCIx dual 1GB nic (I’m out of PCIe slots 🤷‍♂️).

The connections comes from my OPNsense to the server (Proxmox) via a 10Gbps fiber connection.

I want OPNsense to take car of firewalling dividing the neighbor networks with VLANs. The OPNsense part is done and working, I need to assign to each of the 6 1Gbps NIC each VLAN.

I’ve tagged the traffic going into the server via the fiber connection, but now how can I assign each VLAN to each NIC? Thanks!

Edit: Proxmox has nothing to do in the equation, it just happens to be on the same server where the NICs are.

  • SolidGrue@lemmy.worldEnglish
    2·
    5 months ago

    If you just want each physical interface on your server to participate in a single VLAN, set the corresponding switch port as an access port in the desired VLAN, and then configure each server interface as a normal untagged interface.

    You would only do tagged frames (802.1q trunking) if you wanted to support several VLANs on the switch port.