I’m going to start over, I remember I had a few issues with PATH when installing Ansible on a different Mac. I think I can figure them out now.

Nope, but I have now, see above, thanks!

I didn’t do that because I’m apparently a moron :)

I’m trying with

dessalines/lemmy:0.18.0 dessalines/lemmy-ui:0.18.0

In this section

  # actual and only port facing any connection from outside
  # Note, change the left number if port 1236 is already in use on your system
  # You could use port 80 if you won't use a reverse proxy
  - "80:8536"

this fails with Error starting userland proxy: listen tcp4 0.0.0.0:80: bind: address already in use

I tried 8080 instead and got no errors but I wasn’t able to load the Lemmy page.

I can now get the “Apache2 Ubuntu Default Page - It works!” So that’s something.

Here you go! There shouldn’t be any sensitive info in there, I haven’t modified it. The command in the instructions:

wget https://raw.githubusercontent.com/LemmyNet/lemmy-ansible/main/templates/docker-compose.yml

obtained the file and there’s no instruction to modify it prior to running docker-compose up -d which is where it fails.

Edit: Lemmy screws up the formatting. It looks fine pasted into to text area but is messed up when I post. See the above link, that’s what I’m using.

I hope we can both get this done :)

I looked at that one and got confused about how Ansible works. Am I to run those install commands locally or on the VPS? Thanks!

I did, and got further than with the other guides but I couldn’t get the Lemmy page to load and the log was complaining about certificate issues.